BSNL
previous years solved sample placement papers, BSNL DGM, JTO Tech Assistant questions
with answers, BSNL model questions for practice, BSNL technical assistant question
papers with answers and detailed explanations
1. Modern capacitors which have
high capacitance in small size use a dielectric of
(a) Paper
(b) Rubber
(c) Ceramic (Ans)
(d) Mylar
2. The Maximum spectral response
of the germanium and silicon is in the
(a) infrared region
(b) ultraviolet region (Ans)
(c) visible region
(d) x-ray region
3. For an insulating material,
dielectric strength and dielectric loss should be respectively
(a) high and high
(b) low and high
(c) high and low (Ans)
(d) low and low
4. In a distortion factor meter,
the filter at the front end is used to suppress
(a) odd harmonics
(b) even harmonics
(c) fundamental component (Ans)
(d) dc component
5. The coefficient of coupling
between two air core coils depends on
(a) mutual inductance between two
coils only
(b) self inductances of the two
coils only
(c) mutual inductance and self
inductances of the two coils (Ans)
(d) none
6. For a parallel plate capacitor
which is being charged out of the following the incorrect statement is
(a) Energy stored in the
capacitor does not enter it through the connecting wire through the space
around the wires and plates of capacitor
(b) Rate at which energy flows
into this volume is equal to the integration of the poynting vector over the boundary
of the volume between the plates.
(c) The poynting vector points
everywhere radially outward of the volume between plates. (Ans)
(d) The poynting vector points
everywhere radially into the volume between the plates.
7. The presence of alkali oxides
in alumino silicate ceramics is likely to result in dielectric breakdown due to
(a) Polarization
(b) Conductivity (Ans)
(c) Structural homogeneties
(d) Ionization
8. Which of the following will
serve as a donor impurity in silicon
(a) Boron
(b) Indium
(c) Germanium
(d) Antimony (Ans)
9. Electrical contact materials
used in switches, bruses and relays must possess
(a) high -thermal conductivity
and high melting point (Ans)
(b) Low thermal conductivity and
low melting point
(c) High thermal conductivity and
low melting point
(d) Low thermal conductivity and
high melting point
10. An SCR can only be turned off
via it's
(a) cathode
(b) anode (Ans)
(c) gates
(d) none
11. Gold is often diffused into
silicon PN junction devices to
(a) increase the recombination
rate
(b) reduce the recombination rate
(Ans)
(c) make silicon a direct gap
semiconductor
(d) make silicon semi-metal
12. With n nodes and b branches a
network will have
(a) (b+n) links
(b) b-n+1 links (Ans)
(c) b-n-1 links
(d) b+n+1 links
13. When a network has 10 nodes
and 17 branches in all then the number of node pair voltages would be
(a) 7
(b) 9 (Ans)
(c) 10
(d) 45
14. In any atom the potential
energy of an orbiting electron is
(a) always positive
(b) always negative (Ans)
(c) sometime positive, sometime
negative
(d) numerically less than its
kinetic energy.
15. A deplition MOSFET differs
from a JFET in the sense that it has no
(a) channel
(b) gate
(c) P-N junctions (Ans)
(d) Substrate
16. The advantage of a
semiconductor strain gauge over the wire round strain gauge is that
(a) it is more sensitive (Ans)
(b) it is more linear
(c) it is less temperature
dependent
(d) it's cost is low
17. Barrier potential in a P-N
junction is caused by
(a) thermally generated electrons
and holes
(b) diffusion of majority
carriers across the junction
(c) migration of minority
carriers across the junction (Ans)
(d) flow of drift current
18. when an NPN transistor is
properly biased then most of the electrons from the emitter
(a) recombine with holes in the
base
(b) recombine in the emitter
itself
(c) pass through the base to the
collector (Ans)
(d) are stopped by the junction
barrier
19. The deplition voltage for
silicon diode at μo bias is
(a) 0.5 volt
(b) 0.3 volt
(c) 0.7 volt (Ans)
(d) 1.1 volt
20. A UJT can
(a) be triggered by any one of its
three terminals
(b) not be triggered
c) be triggered by two of its
three terminal only (Ans)
(d) be triggered by all of its
terminals only.
23. When a short grounded
vertical antenna has a length L which is 0.05 1 at frequency f and if it's radiation
resistances at f is R Ohms, then its radiation resistance at a frequency 2f
will be
(a) R/2 ohms
(b) R ohms
(c) 2R ohms
(d) 4R ohms (Ans)
24. In a cylindrical cavity
resonator, the two modes which are degenerate would include
(a) TE111 and TM111
(b) TE011 and TM011
(c) TE022 and TM111
(d) TE111 and TM011 (Ans)
25. When an antenna of input
resistance 73 ohm is connected to a 50-ohm line and if the losses are ignored
then its efficiency will be nearly
(a) 0.19
(b) 0.81 (Ans)
(c) 0.97
(d) 1.19
26. The transformer utilization
factor of full wave bridge rectifier is
(a) 0.812
(b) 0.286 (Ans)
(c) 0.693
(d) 0.782
27. When a dominant mode wage
guide not terminated in its characteristic impedance is excited with a
10 GHz signal then if d is the
distance between two successive minima of the standing wave in the guide then
(a) d = 1.5 cm (Ans)
(b) d is less than 1.5 cm
(c) d is greater than 1.5 cm
(d) d= 3cm
28. A two port network having a 6
dB loss will give
(a) an output power which is
one-quarter of the input power (Ans)
(b) an output power which is
one-half of the input power
(c) an output voltage which is
0.707 of the input voltage
(d) an output power which is
0.707 of the input power
29. While transporting a
sensitive galvanometer
(a) the terminals are kept
shorted
(b) critical damping resistance
is connected across the terminals (Ans)
(c) the terminals are kept open
circuited
(d) it does not matter as to what
is connected across the terminals
30. A T type attenuator is
designed for an attenuation of 40 dB and terminating resistance of 75 ohms. which
of the following values represent full series arm R1 and shunt arm R2?
1. R1
= 147 Ω 2. R1 = 153 Ω
3. R1 = 1.5Ω 4. R2 = 3750 Ω
(a) 1 and 3 (Ans)
(b) 1 and 4
(c) 2 and 3
(d) 2 and 4
31. For a transmission line, the
characteristic impedance with inductance 0.294 μH/m and capacitance
62pF/m is
(a) 49 Ω
(b) 60 Ω
(c) 70 Ω (Ans)
(d) 140 Ω
32. When the graph of a network
has six branches with three tree branches then the minimum number of equations
required for the solution of the network is
(a) 2
(b) 3 (Ans)
(c) 4
(d) 5
33. Consider the following
statement of a 2-port network
(1) Z11 = Z22 (2) h12 = h21
(3) Y12 = -Y21 (4) BC - AD = -1
then the network is reciprocal if
and only if
(a) 1 and 2 are correct
(b) 2 and 3 are correct
(c) 3 and 4 are correct
(d) 4 alone is correct (Ans)
34. As a network contain only
independent current sources and resistors then if the values of all
resistors are doubled then the
values of the node voltages are
(a) will become half
(b) will remain unchanged
(c) will become double (Ans)
(d) cannot be determined unless
the circuit configuration and the values of the resistors are known.
35. A iron cored choke is a
(a) A Linear and active device
(b) Non linear and passive device
(Ans)
(c) Active device only
(d) Linear device only
36. Poynting vector wattmeter is
based on
(a) Seebeck effect
(b) Ferranti effect
(c) Induction effect (Ans)
(d) Hall effect
37. Which one of the following is
not a transducer in the true sense?
(a) Thermocouple
(b) Piezoelectric pick-up
(c) Photo voltaic cell
(d) LCD (Ans)
38. The term used to denote a
static device that converts ac to dc, dc to ac, dc to dc or ac to ac is
(a) Converter system (Ans)
(b) Inverter
(c) Chopper
(d) Thyristor
39. When a dipole antenna of 1/8
length has an equivalent total loss resistance of 1.5 Watt then the
efficiency of the antenna is
(a) 0.89159 %
(b) 8.9159 %
(c) 89.159 % (Ans)
(d) 891.59 %
40. In commercial FM
broadcasting, the maximum frequency deviation is normally
(a) 5 KHz
(b) 15 KHz
(c) 75 KHz (Ans)
(d) 200 KHz
No comments:
Post a Comment