BSNL previous years objective type
solved question papers of Electronics, Electrical, Engineering Mechanics
placement papers
1. To neglect a voltage source,
the terminals across the source are
(A) open circuited
(B) short circuited (Ans)
(C) replaced by some resistance
(D) replaced by an inductor
2. Which is a digital
communication system ?
(A) FM
(B) AM
(C) PCM (Ans)
(D) PAM
3. In a resonant circuit, the
power factor at resonance is
(A) zero
(B) unity (Ans)
(C) 0.5
(D) 1.5
4. In TV systems the frame
frequency is
(A) 100
(B) 60
(C) 50
(D) 25 (Ans)
5. The function 3 s has
(s + 1) (s + 2)
(A) one zero, two poles (Ans)
(B) no zero, one pole
(C) no zero, two poles
(D) one zero, no pole
Solution : G (s) =
3s has one zero at s = 0 and two poles at s = - 1, - 2.
(s + 1) (s + 2)
6. One electron volt is
equivalent to
(A) 1.6 * 10-10 J
(B) 1.6 * 10-13 J
(C) 1.6 * 10-16 J
(D) 1.6 * 10-19 J (Ans)
7. Which of the following is
donor impurity element ?
(A) Aluminium
(B) Boron
(C) Phosphorous (Ans)
(D) Indium.
8. The diameter of an atom is of
the order
(A) 10-6 m
(B) 10-10 m (Ans)
(C) 10-15 m
(D) 10-21 m
9. A transistor is basically an
amplifying device for
(A) power
(B) voltage
(C) current (Ans)
(D) all of these
10. If the d.c. valve of a rectified output is 300 V
and peak to peak ripple voltage is 10 V, the ripple factor is
(A) 1.18%
(B) 3.33% (Ans)
(C) 3.36%
(D) 6.66%
Solution : rms value of output
= √3002 + 102 = 300.166 V
Average value = 300 V
Form factor RMS value = 300.166 =
1.00055.
Average value 300
Ripple factor = √(Form factor)2 -
1
= √(1.0005)2 - 1 = 0.0333
= 3.33%.
11. Full wave rectifier output
has ripple factor of
(A) 1.11 (Ans)
(B) 1.21
(C) 1.41
(D) 1.51
12. In a common base connection IE
= 2 mA, IC = 1.9 mA. The value of base current is
(A) 0.1 m (Ans)
(B) 0.2 mA
(C) 0.3 mA
(D) zero
Solution : IE = 2 mA IC
= 1.9 mA
Ib = IE - IC
= (2 - 1.9) = 0.1 mA.
13. For the action of transistor
the base region must be
(A) P-type material
(B) N-type material
(C) very narrow (Ans)
(D) highly doped
14. Compared to a CB amplifier
the CE amplifier has higher
(A) current amplification
(B) output dynamic resistance
(C) leakage current
(D) input dynamic resistance
(E) all of the above (Ans)
15. When a transistor is biased
to cut-off its Y is
(A) 0.5
(B) 0
(C) 1.0 (Ans)
(D) 0.8
16. An ideal voltage amplifier
should have
(A) Ri = 0, R0 = 0
(B) Ri = 0, R0 = ¥
(C) Ri = ¥, R0 = 0 (Ans)
(D) Ri = 0, R0 = ¥
17. Barichausen criterion for
sustained oscillator is
(A) Aβ = 1 Ð00 (Ans)
(B) Aβ = 0
(C) Aβ = 1 Ð1800
(D) A = 1/√β
18. The value of plastic
capacitance for a triode may range from
(A) 2 μF to 12 μF
(B) 20 μF to 120 μF
(C) 2 pF to 12 pF (Ans)
(D) 20 pF to 120 pF
19. A colpitts oscillator uses
(A) tapped coil
(B) inductive feedback
(C) tapped capacitance (Ans)
(D) no tuned LC circuit
20. A typical frequency for a RC
feedback oscillator is
(A) 1 KHz (Ans)
(B) 100 MHz
(C) 1000 MHz
(D) 1 GHz
No comments:
Post a Comment